If the remote control signal receiver is connected to the left display, use a serial cable to connect the RS-232C OUT port on the left display to the RS-232 IN port on the middle display, and use another serial cable to connect the RS-232C OUT port on the middle display to the RS-232 IN port on the right display. If the remote control signal receiver is connected to the right display, use a serial cable to connect the RS-232C OUT port on the right display to the RS-232 IN port on the middle display, and use another serial cable to connect the RS-232C OUT port on the middle display to the RS-232 IN port on the left display.Insert the remote control signal receiver into the CONTROL port on the back of the right display or left display.On the remote control, press MENU then the arrow keys to choose NORMAL, quit and save.Ĭommissioning of Three 70-Inch SHARP HD PN-V701 Displays Configure the Aspect ratio: Point the remote control to the receiver in the lower right corner of the HD SHARP displays.On the remote control, press MENU then the arrow keys to choose SETUP > LOGO SCREEN. Don't display the HP logo during startup: Point the remote control to the receiver in the lower right corner of the HD display.On the remote control, press MENU then the arrow keys to choose OPTION > POWER MANAGEMENT. Disable the power management function (the power supply is controlled by the telepresence host): Point the remote control to the receiver in the lower right corner of the HD SHARP display.Set BAUD RATE to 9600, then press MENU to confirm.
On the remote control, press MENU then the arrow keys to choose SETUP > BAUD RATE.
The process is: Point the remote control to the receiver in the lower right corner of the HD SHARP display. Set the time using the remote control (If you do not set the time, the system prompts you to set it every time you power on the HD displays).
The 70-inch HD display cannot be adjusted using software but can be adjusted using its remote control.
0 kommentar(er)
